ONAN 5500 Installation. On a normal ONAN 8-pin wiring harness the cables are labeled regarding the harness as follows: 2021-01-11 23:46:44

ONAN 5500 Installation. On a normal ONAN 8-pin wiring harness the cables are labeled regarding the harness as follows:

Listed here are typical installation guidelines for an ONAN 5500 Gas/Diesel/Propane having a generator wiring harness that is 8-pin.

Note: For action 7 you will have to buy 14-gauge electric cable for the run from our ShorePower track to your transfer switch.

STEP ONE:

Turn-off your generator AC circuit breakers in order to avoid interruption of coast energy solution during installation and assessment of ShorePower track.

STEP TWO:

Recognize the following 4 cables https://online-brides.net/ in your generator wiring harness.

Make use of a label or tape to mark each cable which means you won’t forget which wire is which.

On a normal ONAN 10-pin wiring harness the cables are labeled regarding the harness the following

NOTE: The pin connections above are typical ONAN connections. Not all the ONAN generators have actually the exact same generator wiring harness connections as some might have been changed by the dealer or RV manufacturer. Make certain you have actually properly identified the 4 cables properly before proceeding with step three.

STEP THREE:

Connect one Posi-Tap to each associated with 4 cables identified in step two.

STEP FOUR:

Result in the connection through the ShorePower track to your Posi-Taps (wiring harness) according to the wiring diagram supplied.

Remember to link the proper cables to the wiring harness even as we utilize red-colored cables more often than once.

On our installation picture we utilized wires that are white expand towards the harness because of location of our device. The closer the installation of our product towards the wiring harness will assist you to utilize the provided 4-foot wire length we offer.

ACTION 5:

ACTION 6:

ACTION 7:

Through the ShorePower Monitor Power Converter ( See wiring diagram B – Transfer Switch Connection):

You may need 14-gauge stranded wire that is electrical the run from our product to your transfer switch.

ACTION 8:

The ShorePower track & the MeanWell Power Converter should both have their light that is green ON if all of the cables, like the cables into the transfer switch, were properly linked. .

SIGNIFICANT NOTE: switching the ALLOW CHANGE On or OFF will not impact the green light on the ShorePower track or MeanWell. In the event that ShorePower track is correctly link along with coast power those two light can be on. The ALLOW CHANGE merely allows or disables monitoring.

This is exactly what a typical set-up will seem like as soon as it is finished. You will see other consumer installation photos by clicking here.

admin Important Link What steps do you need to take to write an article? Nevada Gadgets Unveils Latest Motor vehicle Infotainment Processors, Cellular Systems

RECENT POSTS 最近の投稿